Home » Audio » Speaker » Full range speaker
Full range speaker [message #19660] Fri, 26 December 2003 01:54 Go to next message
Adrian Mack is currently offline  Adrian Mack
Messages: 568
Registered: May 2009
Illuminati (1st Degree)

hah, came accross a 12" full range speaker today :P a bit stupid.

http://www.eighteensound.com/pdf/12TC300.pdf

you need acrobat reader to see it.

I always wonder how could a fullrange speaker sound good when its able to develope parallax across the diaphram even. Notice the rather bumpy response up high on that speaker. It does 70Hz-16KHz

Re: Full range speaker [message #19661 is a reply to message #19660] Fri, 26 December 2003 06:49 Go to previous messageGo to next message
JLM is currently offline  JLM
Messages: 69
Registered: May 2009
Viscount
That driver looks to be mixed bag:

1.) Very good efficiency;

2.) Good power handling capacity;

3.) Ragged high end response (not unusual for extended range drivers);

4.) Severe roll off above 15,000 Hz (to be expected from a large driver);

5.) Severe off axis roll off of higher frequencies (again to be expected given the driver size);

6.) Bass roll off starts around 150 Hz (quite unexpected from a 12 inch driver, and this in a cabinet!);

7.) Specified bass response is severely overstated (this driver needs a sub that could use a smaller driver!);

8.) With Qt = 0.43 this could be a good candidate for bass reflex, transmission line, TWQP, open/infinite baffle.


Don't know the price (or recognize the brand) but a number of 4 - 8 inch diamter Fostex drivers that provide more extended frequency response with less beaming, but somewhat less efficient.

Re: Full range speaker [message #19662 is a reply to message #19660] Fri, 26 December 2003 11:03 Go to previous message
hurdy_gurdyman is currently offline  hurdy_gurdyman
Messages: 416
Registered: May 2009
Illuminati (1st Degree)
Now that is an interesting driver. The graph shows the response in a 50cu. litre box tuned to 60Hz, but doesn't show what kind of box. With a box that boosts low end, this could be a driver that covers all the important frequencies and just needs a sub for the lowest couple of octives and a super tweeter for the highest sounds. With that kind of sensitivity, any amplifier could drive it, and it comes in both 8 ohm and 16 ohm, to get even better amp matching (on a typical tube amp with the 16 ohm setting, these speakers could really put out some efficient sound). Sitting a bit off axis should tame the high frequency peak.
Of course, you can't tell what it will sound like untill you try it. ;^)

Dave

Previous Topic: Altec Valencia tweaks...
Next Topic: Has anyone heard of DCC Audio?
Goto Forum:
  


Current Time: Fri Nov 22 17:57:57 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest