I am doing a 3 way speaker project that I already know will be used on a single amplifier so I can't biamp it. The mid and tweeter need to be padded, and I am considering different ways to do it. I can use transformers or resistors. Questions:
1. If I use transformers for padding, where can I get them? 2. If I use resistors, should I use carbon resistors or some length of very small wire? 3. Whether I use resistors or transformers, the mid and tweeter need conjugate compensation filters that have a resistor. Same question, what kind of resistor is best to use?
The best way to go about it is to use temporary wire-wound 25ohm potentiometers to determine the required values in circuit and then put in the appropriate sized high power(12 watt) Mills non-inductive resisitors, available at Parts Express.
Wayne Parham Messages: 18787 Registered: January 2001
Illuminati (33rd Degree)
Small wire won't allow much power, acting like a fuse instead. I'd suggest a good quality non-inductive resistor is probably your best bet. Both tubes and solid state alike use carbon resistors within the amp.
Posting Rules
Members
Search
Help
Register
Login
Get a T-Shirt!
