mellotron Messages: 5 Registered: May 2017 Location: Ontario, Canada
Esquire
Hi,
I'm sourcing parts for a 4pi build and was wondering about the value for the Rs resistor rated at 16 ohms for the B&C 250. There weren't any 16 ohm available. I was just wondering if it would be ok to use something a bit higher (18ohm) or lower (12ohm) in this position. Thanks for any assistance.
Wayne Parham Messages: 18678 Registered: January 2001
Illuminati (33rd Degree)
Either would work, but I'd go with the 18Ω part. The 12Ω resistor will provide more damping, which is good, but it will also attenuate the driver too much, which we don't. Better yet, order the right part online and have it shipped to you.
Posting Rules
Members
Search
Help
Register
Login
Get a T-Shirt!
