Home » Sponsored » Pi Speakers » 2 Pi Tower Bass reflex port
2 Pi Tower Bass reflex port [message #81918] Mon, 25 January 2016 17:53 Go to next message
kulivontot is currently offline  kulivontot
Messages: 3
Registered: May 2014
Esquire
Hi Wayne,
I finally got around to building up the 2pi tower kit you shipped me over a year ago. It's sounding pretty good! Even off of my cheesy 20W TA2020 amp and my shoddy woodworking skills.
However, during the build, I forgot to cut the 4.5" hole in the back of the speaker for the bass reflex port. I haven't bothered to try measuring the frequency response yet, but I'm curious what the overall effect is for not adding the bass reflex port. At some point I will unmounts the drivers and sand, prime, and paint the whole cabinet, and at that point I will probably take the time to do it right.
Re: 2 Pi Tower Bass reflex port [message #81919 is a reply to message #81918] Tue, 26 January 2016 12:02 Go to previous message
Wayne Parham is currently offline  Wayne Parham
Messages: 18272
Registered: January 2001
Illuminati (33rd Degree)

So it's just a large sealed box. Response isn't bad like that, but it's better when you vent it as designed.

Previous Topic: 4Pi upgrade information
Next Topic: I've always wondered about this
Goto Forum:
  


Current Time: Sat May 28 18:24:41 CDT 2022

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Smith & Larson Audio
Smith & Larson Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest