sony PS-LX250H drive belt [message #11554] |
Sun, 11 April 2004 18:14 ![Go to next message Go to next message](/forum/theme/AudioRoundTable/images/down.png) |
dramius
Messages: 3 Registered: May 2009
|
Esquire |
|
|
During a move, the drive belt somehow got knocked off, and i have no idea where to put it back on. I went to online support, they we're morons and told me to look at the wrong page of the manual, looked at the manual, the diagram was of low quality and said nothing about the entire drive belt setup.They told me to ship it to their repair center and i don't have that kind of money.I was wondering if anyone could tell me how to put it back on?
|
|
|
Re: sony PS-LX250H drive belt [message #11557 is a reply to message #11554] |
Wed, 14 April 2004 08:54 ![Go to previous message Go to previous message](/forum/theme/AudioRoundTable/images/up.png) ![Go to next message Go to next message](/forum/theme/AudioRoundTable/images/down.png) |
![](http://audioroundtable.com/forum/images/custom_avatars/5.gif) |
Wayne Parham
Messages: 18756 Registered: January 2001
|
Illuminati (33rd Degree) |
|
|
I'm not familiar with that turntable. But I think I might be able to help, if it's like other turntables. Check this and see, is there a rubber mat under which you find a metal platter? If so, are there holes in the platter that you can see inside? This is common on many belt-drive turntables. If this is the case on yours, you will want to remove the platter and place the belt around the belt path on the platter, gently holding the belt through the access holes. Place the platter back on the spindle and thread the belt over the drive motor pulley. Stretch the belt as little as possible when you do this. I hope that helps and you're back in business.
|
|
|
|
|
|
|
|