I bought my husband a 1000 watt speaker system for his birthday this past September, but the system isn't what I thought it would be. Although it does get loud, it doesn't get anywhere near as loud as I thought it would, or as loud as I would LIKE IT TO. I thought higher wattage meant louder; was I wrong?
Wayne Parham Messages: 18783 Registered: January 2001
Illuminati (33rd Degree)
The power rating of a speaker only tells you how much power it can handle before damage. Its sensitivity rating tells you how loud it is. Sensitivity is a measure of efficiency, in that it tells you how much sound is produced at a specific drive voltage or power level. Typical sensitivity ratings are 93dB@1W/1M or 93dB@1M/2.83v. These examples are interpreted as meaning the speaker produces 93dB when measured one meter away given one watt or 2.83 volts, respectively.
Wayne Parham Messages: 18783 Registered: January 2001
Illuminati (33rd Degree)
The "wattage" doesn't matter as to how loud a speaker is at a given drive level. That is described by its "sensitivity" specification. However, the maximum output can be known by three values - max power, sensitivity and compression. At low frequencies, the limit is usually excursion and not thermal, but basically if you know the power limit and sensitivity of a speaker, you can know its maximum SPL.
Thanks for explaining this, Wayne. I thought I knew a pretty good bit about stereos and home theaters, but I was completely wrong about what I thought I knew!
Posting Rules
Members
Search
Help
Register
Login
Get a T-Shirt!
