AudioRoundTable.com: Pi Speakers

Home » Sponsored » Pi Speakers » H290C dimensions (dimensions for the recessed cutout)

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: H290C dimensions [message #73439 is a reply to message #73438]

Tue, 31 July 2012 17:18

Wayne Parham
Messages: 18674
Registered: January 2001

Illuminati (33rd Degree)

zheka wrote on Tue, 31 July 2012 16:48

If I want to flush mount, should I use 1" MDF panel for the front baffle or 3/4" panel is adequate in your opinion? Given that the recess is 1/4" deep.

What I like cabinetmakers to do is to cut a ring that surrounds the baffle cutout both for the midwoofer and tweeter. This ring can be cut from scrap wood, and is only there to provide some extra thickness in the area where the router cuts into the baffle. Glue it in place behind the baffle, and install the T-Nuts or threaded inserts into it.

Report message to a moderator

Re: H290C dimensions [message #73446 is a reply to message #73439]

Wed, 01 August 2012 07:18

zheka
Messages: 80
Registered: June 2012
Location: Chicago burbs

Viscount

Is it safe to assume that this kind of support rings do not require any cabinet volume compensation?

Report message to a moderator

Re: H290C dimensions [message #73447 is a reply to message #73446]

Wed, 01 August 2012 07:46

Wayne Parham
Messages: 18674
Registered: January 2001

Illuminati (33rd Degree)

That's right, no adjustment necessary. They don't displace much internal volume at all.

Report message to a moderator

Re: H290C dimensions [message #74650 is a reply to message #73415]

Thu, 29 November 2012 12:11

dheflin44
Messages: 47
Registered: November 2012
Location: Carrollton, TX

Baron

Sorry to belabor this, but I want to be sure to get the baffle recesses right. In the H290C picture below, it looks like the corner radius is about the same height as the top and bottom flanges which are about 0.8", right?