I need some help. I have this preamp (ACA2b from Nohr) and the blue LED is just too bright!

Can't I put a resistor in series with one of the leads and dim this?

But, which lead, and about what value should I try? How do I identify the correct lead of the blue LED?

Incidentally, other than this little issue I love the preamp.

Thanks,
Mark

Wow! Those resistor values are even more rangey than I'd imagined. I'll play around with it until I get it right. Thanks for the answer.

This blue LED is so bright at night...it's like staring into the sun! I've been getting tired of putting a credit card in front of it!

Nice preamp though...uses 6922's mounted on a circuit board. $400 DELIVERED from Thailand. Not bad.

Thanks,
Mark

I'd strat here and decide if you need to go lower/brighter, or higher/dimmer.

Joe