AudioRoundTable.com: Pi Speakers » Adding DE250 to 4 Pi?

Home » Sponsored » Pi Speakers » Adding DE250 to 4 Pi?

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Adding DE250 to 4 Pi? [message #52710]

Tue, 07 October 2008 10:24

GarlandGarland
Messages: 60
Registered: May 2009

Viscount

Wayne or others,

I've updated the crossover and love the sound. Now I've purchased a pair of B&C DE250 drivers to go in. Am I right to assume that I hook them up as in the crossover schematic, with the black post to wire 1+ and the red to 1- and the woofer red to 2+ and black to 2-? Are the two drivers out of phase?

Just want to make sure I hook em up right the first time!

Thanks,

Garland

Report message to a moderator

Re: Adding DE250 to 4 Pi? [message #52711 is a reply to message #52710]

Tue, 07 October 2008 11:57

Matts
Messages: 359
Registered: May 2009

Grand Master

B&C's are like many JBL's- the black is forward motion with pos. signal, opposite of most other speakers. I put a B&C in one side of mine to a/b them, and the result clear to all who listened.

Report message to a moderator

Re: Adding DE250 to 4 Pi? [message #52712 is a reply to message #52710]

Tue, 07 October 2008 12:03

Wayne Parham
Messages: 18787
Registered: January 2001

Illuminati (33rd Degree)

Connect the drivers as shown in the schematic. Also, be sure to change R1 and R2, because voltage sensitivity of the DE250 is a little higher than the PSD2002.

Report message to a moderator

Re: Adding DE250 to 4 Pi? [message #52714 is a reply to message #52712]

Tue, 07 October 2008 15:10

GarlandGarland
Messages: 60
Registered: May 2009

Viscount

Hi Wayne,

I may be confused but note 6 in the crossover schematic calls for R1a, b, c and d to be changed but does not mention the R2 chain being changed. Is there an error?

Report message to a moderator

Re: Adding DE250 to 4 Pi? [message #52715 is a reply to message #52714]

Tue, 07 October 2008 15:54

Wayne Parham
Messages: 18787
Registered: January 2001

Illuminati (33rd Degree)

You're not confused, you're right. I tend to think of R1/R2 as a pair but in this case, the value of R2 remains the same. Here's a chart of R1/R2 values at various padding levels:

Compensation component values
Report message to a moderator

Previous Topic:	4 pi plans
Next Topic:	Recommended toe in

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Nov 24 05:43:32 CST 2024