AudioRoundTable.com: Pi Speakers

Home » Sponsored » Pi Speakers » 4pi port question

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

4pi port question [message #52526]

Sat, 23 August 2008 13:56

ecc83
Messages: 19
Registered: May 2009

Chancellor

Is it possible to convert the rectangular port to a round one?
I have some 4" ports and if its possible i will use them in the 4pi.

Thanks
Frank

Report message to a moderator

Re: 4pi port question [message #52530 is a reply to message #52526]

Sun, 24 August 2008 22:13

Wayne Parham
Messages: 18786
Registered: January 2001

Illuminati (33rd Degree)

You could use a round port of the same length and cross section area except that it won't fit. The baffle layout is pretty tight.

Report message to a moderator

Re:I like the molding nt [message #52533 is a reply to message #52530]

Sun, 24 August 2008 22:39

Bill Epstein
Messages: 1088
Registered: May 2009
Location: Smoky Mts. USA

Illuminati (2nd Degree)

Report message to a moderator

Re: 4pi port question [message #52534 is a reply to message #52530]

Mon, 25 August 2008 10:24

ecc83
Messages: 19
Registered: May 2009

Chancellor

Thanks very much- i understand.

Is it possible to round the corners for the port cutout in the baffle?

I have a router and the cutout would be easier to do...

Frank

Report message to a moderator

Re: 4pi port question [message #52535 is a reply to message #52534]

Mon, 25 August 2008 13:03

Wayne Parham
Messages: 18786
Registered: January 2001

Illuminati (33rd Degree)

Absolutely. Rounding the corners with a router is just fine. You just about have to do it that way. After cutting the hole with a router, you can square the edges with a file if you want, but it won't hurt anything to leave them rounded in the corner edges.

Report message to a moderator

Re: 4pi port question [message #52536 is a reply to message #52535]

Mon, 25 August 2008 22:29

Bill Epstein
Messages: 1088
Registered: May 2009
Location: Smoky Mts. USA

Illuminati (2nd Degree)

I found that cutting the port hole with a jigsaw slightly undersize, then carefully lining up and gluing on the port worked great. Eliminated the need for a router template to get the hole right.

After the veneer was applied, I then routed the hole using the port as a guide with a 1/4" flush trim bit. That left just a 1/4" round in the corners which looks good.

Be sure there's no dried glue on the interior surface of the port to spoil it's use as a guide.

Report message to a moderator

Previous Topic:	Wow! Does this ever show off the new crossover!
Next Topic:	What a strange 24 hours! Come ramble with me.

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue Nov 26 16:25:13 CST 2024