AudioRoundTable.com: Pi Speakers

Home » Sponsored » Pi Speakers » Pi Speaker Forum

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Pi Speaker Forum [message #34175]

Fri, 16 November 2001 08:08

replay
Messages: 284
Registered: May 2009

Grand Master

hi wayne and fellow inmates. as time goes by the speakers are sounding better but i still think they lack bass and high end treble. any suggestions?

cheers,
george

Report message to a moderator

Re: jbl 4655 second take [message #34180 is a reply to message #34175]

Fri, 16 November 2001 13:20

Michaelz
Messages: 25
Registered: May 2009

Chancellor

Hi, Replay:

According to the spec sheet, response falls off at 100Hz on the low end and 10kHz on top.

Regards,

Michael

JBL 4655 spec sheet

Report message to a moderator

Re: jbl 4655 second take [message #34181 is a reply to message #34180]

Fri, 16 November 2001 14:04

replay
Messages: 284
Registered: May 2009

Grand Master

not a very impressive response chart, no top, no bottom and a big dip at crossover. should i modify these, part them out or ebay them?

cheers,

george

Report message to a moderator

Re: jbl 4655 second take [message #34182 is a reply to message #34181]

Fri, 16 November 2001 15:26

Wayne Parham
Messages: 18686
Registered: January 2001

Illuminati (33rd Degree)

You can EQ the top end to get a bit more extension, but not much. On the bottom end, I think you'll need a sub. Speakers like these are designed to be used with a sub, so they don't use alignments that offer deep bass extension. As for the dip at 1.5kHz, looks like a crossover problem to me. I'd say they would benefit from a little work there.

Report message to a moderator

Re: jbl 4655 second take [message #34183 is a reply to message #34182]

Fri, 16 November 2001 16:37

replay
Messages: 284
Registered: May 2009

Grand Master

hi wayne, i'm leaning towards selling them at this point. on the underside the quality words "made in mexico" are printed.

cheers,

george

Report message to a moderator

Re: jbl 4655 second take [message #34239 is a reply to message #34182]

Wed, 21 November 2001 10:30

spkrman57
Messages: 522
Registered: May 2009

Illuminati (1st Degree)

I plan to swap my 2205a for the 2032h since the 4655's are approx 2.5 cubic foot enclosures and would be close to the 2.1 cubic foot that pi align calls for on the 2205a. just my 2 cents.

Ron aka spkrman57

Report message to a moderator

Previous Topic:	DECISION TIME AGAIN - Theatre Three or Modified Theatre Four?
Next Topic:	Mr.Parham could you please send me the theatre pi4 plans

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed May 08 15:23:24 CDT 2024