Home » Audio » Speaker » Probably a dumb question, but I'm old (and new....)
Probably a dumb question, but I'm old (and new....) [message #21338] Fri, 04 November 2005 11:59 Go to next message
ARTIdaho is currently offline  ARTIdaho
Messages: 20
Registered: May 2009
Chancellor

I am new to quality spers (have a set of KLH cheap towers) and am looking at every angle I can for something I can afford. I have run accross the letters BLH on several occasions and do not know if it is a mfg designator of a type of system......searches on the net haven't given me a clue. Please help, TIA, Chuck

Report message to a moderator

Re: Probably a dumb question, but I'm old (and new....) [message #21339 is a reply to message #21338] Fri, 04 November 2005 12:46 Go to previous messageGo to next message
GM is currently offline  GM
Messages: 114
Registered: May 2009
Viscount
Greets!

Back Loaded Horn, though few designs on the net actually are due to the need to keep it as small as practical (though still large) and not roll off the driver's mids/HF bandwith (BW).

GM

Report message to a moderator

Re: Probably a dumb question, but I'm old (and new....) [message #21340 is a reply to message #21338] Sat, 05 November 2005 09:15 Go to previous message
lon is currently offline  lon
Messages: 760
Registered: May 2009
Illuminati (2nd Degree)
This should be a good and current representation of a BLH
linked below.

I became fascinated with speakerbuilding some years ago.


Lots of designs, lots of possibilities for scratch-builts
which don't cost a lot and sound great.

Report message to a moderator

Previous Topic: Need Opinions on a Open Baffle Linear Array
Next Topic: Diatone
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Mon May 13 21:35:06 CDT 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Smith & Larson Audio
Smith & Larson Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest