Home » Audio » Speaker » Fostex break- in proceedures
Fostex break- in proceedures [message #20851] Mon, 18 April 2005 14:01 Go to next message
Peter Swartz is currently offline  Peter Swartz
Messages: 56
Registered: May 2009
Baron
Well I just received my new Fe206's. It will be a couple weeks before my cabinets will be completed. What is the best way for me to break-in these drivers before hand so I'll be good to go in a couple weeks? Thanks, Pete

Report message to a moderator

Re: Fostex break- in proceedures [message #20852 is a reply to message #20851] Mon, 18 April 2005 15:03 Go to previous messageGo to next message
Bill Wassilak is currently offline  Bill Wassilak
Messages: 402
Registered: May 2009
Illuminati (1st Degree)
Couple of ways:

1)Signal generator set to a low freq. probably around 60hz for that speaker, through an amp to loosen up the suspensions of the cone. Be careful because theres not much xmax on Fostex.

2)Bass heavy music playing through them for several hours.

HTH
Bill W.

Report message to a moderator

Re: Fostex break- in proceedures [message #20853 is a reply to message #20852] Mon, 18 April 2005 16:01 Go to previous message
GarMan is currently offline  GarMan
Messages: 960
Registered: May 2009
Illuminati (2nd Degree)
and place the drivers face-to-face, with one them wired in reverse if you don't want to hear them too much.

Report message to a moderator

Previous Topic: Audio Nirvana Speakers
Next Topic: Ramblings on Cabinet Building for Tangbands
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Mon May 13 14:02:53 CDT 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Smith & Larson Audio
Smith & Larson Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest