Home » Sponsored » Pi Speakers » Driver selections (4pi)
Re: Driver selections [message #66830 is a reply to message #66813] Fri, 01 April 2011 14:16 Go to previous messageGo to next message
JakobR is currently offline  JakobR
Messages: 8
Registered: March 2011
Esquire
I recieved the plans, thank you very much.

I also got the H290's today. I just tried mounting them to my 2426H but had a hard time to reach the skulls of the three screws to attach the driver. It is very tight between the horn and the screws. My screw skulls are 11mm wide, is this bigger than normal? What kind of tool do you use?

Kind regards,

Jakob
Re: Driver selections [message #66835 is a reply to message #66830] Fri, 01 April 2011 15:13 Go to previous message
Wayne Parham is currently offline  Wayne Parham
Messages: 18787
Registered: January 2001
Illuminati (33rd Degree)

That is a tight fit when you use the three-hole mounts instead of the two. When using the two hole mounts, it's easy. But the three hole mounts are right up close to the body. I use an open end socket wrench to tighten these bolts.

Previous Topic: Wayne, which speaker for PA tops?
Next Topic: One pi plans please
Goto Forum:
  


Current Time: Fri Nov 22 17:51:56 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest