Home » Sponsored » Pi Speakers » 2226j (16 ohm) usable? (question about 4pi)
Re: 2226j (16 ohm) usable? [message #66545 is a reply to message #66532] Sun, 06 March 2011 22:06 Go to previous message
Wayne Parham is currently offline  Wayne Parham
Messages: 18787
Registered: January 2001
Illuminati (33rd Degree)

A person could do a 2.5-way to good effect. Just low-pass the lower woofer at 200Hz or so. That wouldn't take much redesign because the top (mid)woofer and tweeter crossover and physical relationship can (and should) remain the same. But a person would still need to analyze standing waves inside the cabinet and go through a test/measurement cycle to dial it in and make sure everything comes together.

Previous Topic: Tweeter Change (again !)
Next Topic: Four Pi R3 Mounting
Goto Forum:
  


Current Time: Fri Nov 22 17:35:37 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest