Home » Sponsored » Pi Speakers » 2pi studio build (some progress)
Re: 2pi studio build (some progress) [message #67869 is a reply to message #67867] Thu, 26 May 2011 18:17 Go to previous messageGo to next message
justphil is currently offline  justphil
Messages: 114
Registered: December 2010
Viscount
I didn't build a "they", I built just 1 =) It sounds awesome in my system. I wanted a 2pi studio for my center channel and now I will build my 2pi towers around the end of the year if money allows. Then I will finish it all off with a pair of 1pis and another sub. At that point I know I won't need to change anything for a looooong time =)
Re: 2pi studio build (some progress) [message #67870 is a reply to message #67815] Thu, 26 May 2011 19:52 Go to previous message
Bill Epstein is currently offline  Bill Epstein
Messages: 1088
Registered: May 2009
Location: Smoky Mts. USA
Illuminati (2nd Degree)
Wayne Parham wrote on Mon, 23 May 2011 18:14

Clamp pressure length all depends on the glue you use. I think Tightbond or PL adhesive is going to be fully set (or at least enough to no longer need clamping pressure) in a few hours. But some white glues need longer.




Like Wayne said, you can remove the clamps in as little as an hour with PVA glues like Titebond or Elmers but I would avoid moving them around much or especially routing the speaker holes for 24 hours.
Previous Topic: Request 4Pi and 2Pi plans please
Next Topic: Three Pi push-pull sub plans?
Goto Forum:
  


Current Time: Fri Nov 29 03:55:22 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest