AudioRoundTable.com: Pi Speakers » crossover questions...

Home » Sponsored » Pi Speakers » crossover questions...

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

crossover questions... [message #42629]

Wed, 08 October 2003 05:52

Larry Acklin
Messages: 54
Registered: May 2009

Baron

I have a pair of JBL 2425J 1" exit drivers, 16 ohm. If I want to use them in a 2 or 3 way box, how can I reconfigure the crossover so it treats the drivers properly, but still presents 8 ohms to the amp?

They would be bolted to CD horns, so the top octive compensation would be a plus.

I know that the cap values change for a 16 ohm driver, but I'm a little hazy on what determines the nominal value the completed system presents to the amp.

Yes, I know I could just tack a 16 ohm resistor across the driver, but that kills the sensitivity.

Also, would it be possible to design a passive crossover (high-pass)
that could do the same thing- present an 8 ohm load, but have the 16 ohm driver inside?

Thanks

Larry

Report message to a moderator

crossover answers [message #42637 is a reply to message #42629]

Wed, 08 October 2003 14:40

Wayne Parham
Messages: 18792
Registered: January 2001

Illuminati (33rd Degree)

You answered your own question - You can put a resistance in shunt to set the load. If the compression horn needs padding and/or HF compensation, you can form a voltage divider and also be able to use it to set filter Q and high-frequency augmentation. Alternately, you can use a transformer for impedance matching. It's all a balancing act, of setting goal and priorities and building to suit.

Report message to a moderator

Previous Topic:	THD woofer measurement-what mic
Next Topic:	Hi Guys! How about the ESG1 in a Theater 4?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue Dec 03 15:23:23 CST 2024