AudioRoundTable.com: Group Build

Home » Audio » Group Build » 6v6v6

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

6v6v6 [message #30486]

Sat, 12 February 2005 07:11

Manualblock
Messages: 4973
Registered: May 2009

Illuminati (13th Degree)

So is the 100ma rating on the power trans adequate to run PP 6v6's?

Report message to a moderator

Re: 6v6v6 [message #30490 is a reply to message #30486]

Sat, 12 February 2005 13:45

Damir
Messages: 1005
Registered: May 2009

Illuminati (2nd Degree)

Yes, but...:-) See some tube data for 6V6 and EL84 (similarly). With "standing current" of about 30-40 mA per tube, and Ua of 250-300V we can expect about 4-5 W in PP triode A class, or about double in UL. Pentode and AB class ~15W or little more. With max. power, our 60-80 mA "standing current" would rise very close to the 100mA, and better use "economical" driver tube that work with only a few mA...

Report message to a moderator

6v6x2 [message #30516 is a reply to message #30490]

Sun, 13 February 2005 18:45

PakProtector
Messages: 935
Registered: May 2009

Illuminati (2nd Degree)

Hey-Hey!!!,
I think the L-C filter would gain us something, especially if a conservative rectifier was used. 400 volts @ 100 mA is 40 watts. 3A of 6.3 and 5 VAC is about 30 watts. 70VA core will have more to give the HV is full use of the heater taps is not made. It will not be all that close I suspect.

Class A bias with 6V6's in U-L and using the middle taps and a 6BK7B driver pair( figure ~6 mA for that stage or so ) will give B+ of ~240VDC. No biggie....
regards,
Douglas

Report message to a moderator

Previous Topic:	CCS built
Next Topic:	RIAA preamp?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Nov 03 17:51:41 CST 2024