Dual 601 with Digitac 300 SE cartridge (equivalent to Dual M20E). One channel gives a poor output; I cleaned the contacts inside the tone arm; it helps for a day or so and then the channel is out or poor again. I would like to solder the connection but that's not simple. Any suggestions? Harry
Wayne Parham Messages: 18793 Registered: January 2001
Illuminati (33rd Degree)
Hi Harry,
Sounds to me like you've identified the problem, so 1/2 of the deal is done. At least you know the cause is a bad connection. Now the matter is what to do to solve it.
Where is the connection that you've cleaned? What's to stop you from simply re-wiring? I think I'd be most comfortable with that solution. Just in case the problem was caused by an open inside a wire, probably as it enters a crimp connection. You could be moving that when you clean it, making it work for a little while. If you can re-wire, that will replace both the connector and the wire.
Posting Rules
Members
Search
Help
Register
Login
Get a T-Shirt!
