Home » Sponsored » Pi Speakers » 7pi crossover
7pi crossover [message #77183] Fri, 12 July 2013 14:34 Go to next message
jgoodd8050 is currently offline  jgoodd8050
Messages: 28
Registered: February 2010
Chancellor
Wayne,

My room is on the dead side and I'd like get a little more from the top horn on my 7pi's without resorting to eq. I know very little about crossovers... Can this be accomplished by removing a resistor or two from top horn's circuit?

Thanks for the help.
Jeremy

Report message to a moderator

Re: 7pi crossover [message #77184 is a reply to message #77183] Fri, 12 July 2013 18:06 Go to previous messageGo to next message
Wayne Parham is currently offline  Wayne Parham
Messages: 18787
Registered: January 2001
Illuminati (33rd Degree)

Yes, you can change the R1/R2 values as shown in the chart at the link below. For more top end, use less attenuation.

Report message to a moderator

Re: 7pi crossover [message #77187 is a reply to message #77184] Sat, 13 July 2013 22:46 Go to previous message
jgoodd8050 is currently offline  jgoodd8050
Messages: 28
Registered: February 2010
Chancellor
Perfect! Thank you.

Report message to a moderator

Previous Topic: Room Size 18X36 Cathedral Ceiling
Next Topic: Plan Request
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Sat Nov 23 21:00:22 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest