AudioRoundTable.com: Pi Speakers

Home » Sponsored » Pi Speakers » one-Pi X-over (1038 Question)

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

one-Pi X-over [message #61038]

Sun, 27 September 2009 00:21

Wayne-o
Messages: 225
Registered: May 2009

Master

When you used the piezo tweeter what x-over parts did you use on the tweeter ? Thanks again

Report message to a moderator

Re: one-Pi X-over [message #61040 is a reply to message #61038]

Sun, 27 September 2009 09:12

Wayne Parham
Messages: 18783
Registered: January 2001

Illuminati (33rd Degree)

I didn't use any passive parts in the tweeter circuit. You can modify the crossover point and slope by using a crossover, but in this case, I didn't wan't that.

Report message to a moderator

Re: one-Pi X-over [message #61042 is a reply to message #61040]

Sun, 27 September 2009 14:30

Wayne-o
Messages: 225
Registered: May 2009

Master

Is the new replacement piezo from parts express for the 1038 worth considering.? Or is it a totally different bird ???

Report message to a moderator

Re: one-Pi X-over [message #61043 is a reply to message #61042]

Sun, 27 September 2009 15:30

Wayne Parham
Messages: 18783
Registered: January 2001

Illuminati (33rd Degree)

I haven't found any good replacement piezo's, no. That's why I stopped using them.

The original Motorola parts sounded good, but there were always a lot of cheap Chinese knock offs that gave piezos a bad name. That and the cheapo prosound speakers with a horizontal array of them, those were the worst. But back to the original question, that of individual parts: My experience with non-Motorola (later CTS) piezos has been very bad quality and poor sound.

Report message to a moderator