AudioRoundTable.com: Silicon Valley » Marshall AVT100 Problems

Home » Audio » Silicon Valley » Marshall AVT100 Problems (Effects)

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Marshall AVT100 Problems [message #60613]

Mon, 17 August 2009 02:52

gill
Messages: 1
Registered: August 2009

Esquire

I recently got an AVT100 for free of a mate after he upgraded his amp. The amp is as good as it gets for a freebee but the "digitalFX" don't work. He did say that he remembers it did work when he sat on top of the amp sometimes or gave it a firm knock on the lid. What are the options for repair, has anyone ever heard of the amp still working correctly but the effects stopping?

I am an electrician by trade and have done a my share of electronics and circuitry work, but i think this might be out of my league unless there is a common problem with them that can be explained or even some suggestions. I am getting a new setup in a few months but would like to keep this one in full working condition as a spare.

Thanks everyone

Report message to a moderator

Re: Marshall AVT100 Problems [message #60614 is a reply to message #60613]

Mon, 17 August 2009 08:51

Wayne Parham
Messages: 18793
Registered: January 2001

Illuminati (33rd Degree)

Sounds to me like it might be a cold solder joint or mechanical connection. I would re-heat every solder joint and flow in a small amount of new solder. I would also reseat every mechanical connection and socketed component by removing and reinserting them. Start with that, it may fix the problem.

Report message to a moderator

Previous Topic:	Distortion
Next Topic:	plans for single frequency electronic crossover?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Dec 21 08:20:04 CST 2024