Home » Sponsored » Pi Speakers » pi 8 question
pi 8 question [message #51274] Tue, 24 July 2007 09:56 Go to next message
cheyoung is currently offline  cheyoung
Messages: 5
Registered: May 2009
Esquire

May I know what is the cut off frequency for the pi 8 mid horn?

cheyoung

Re: pi 8 question [message #51275 is a reply to message #51274] Tue, 24 July 2007 11:49 Go to previous messageGo to next message
Wayne Parham is currently offline  Wayne Parham
Messages: 18783
Registered: January 2001
Illuminati (33rd Degree)

There is a lot of good information about the midhorn in the post below, including response charts with and without the crossover and tweeter.
Re: pi 8 question [message #51276 is a reply to message #51275] Tue, 24 July 2007 11:57 Go to previous messageGo to next message
cheyoung is currently offline  cheyoung
Messages: 5
Registered: May 2009
Esquire
hi wayne,

if i would to make it round then should i based on 150hz free space ?

cheyoung

Re: pi 8 question [message #51278 is a reply to message #51276] Tue, 24 July 2007 16:11 Go to previous message
Wayne Parham is currently offline  Wayne Parham
Messages: 18783
Registered: January 2001
Illuminati (33rd Degree)

It depends where you will be using the horn. If you plan to use it out in the open but standing on the ground, model it in half space. It will be close enough to the ground to get some loading at the lowest frequencies. Changes like this are pretty substantial though, so I wouldn't expect it to act the same.


Previous Topic: Tweeter Attenuation on Pi 8s
Next Topic: 7 Pi plans please
Goto Forum:
  


Current Time: Tue Nov 05 23:30:09 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest