Show: Today's Messages :: Unanswered :: Navigator :: Polls
86 Search Results Found
1 Forum: Speaker «» Posted on: Sat, 24 October 2015 05:50 «» By: jonone
Mono "flanking sub"
… this is what I'm sending to my single "flanking sub" which is a down firing a acoustic elegance td15h+ Apollo in a 17.5" cube with its on plate amp, it's a very clean driver. I have an Av amp which at the moment is set to "fronts…
2 Forum: Silicon Valley «» Posted on: Mon, 30 March 2009 17:27 «» By: Wayne Parham
Active Sub Crossover
…risers and toed-in 45°, subs on the floor flanking them. The sound system and listening area is not symmetrical in the room, however, everything is shifted about four feet to the right, so the right channel is nearer the side wall than the left. It …
3 Forum: Home Theater «» Posted on: Mon, 06 November 2017 10:51 «» By: Wayne Parham
Re: The subwoofer volume and crossover
…numbers" in my earlier post above. Flanking subs are setup to blend generally in the 100-200Hz region, but in practice the blending region is shifted a little lower than that. Distributed multisubs are always used below 100Hz but usually below …
4 Forum: Speaker «» Posted on: Tue, 23 April 2019 13:56 «» By: jonone
Passive radiator flanking sub/woofer.
…the crossover up to 150hz. Not a true flanking sub approach as the room doesn't allow for the subs to be placed away from directly below the speakers. I do have the subs turned 180degress so there facing the rear walls to act like a woofer in a …
5 Forum: Pi Speakers «» Posted on: Tue, 24 January 2012 21:21 «» By: NWCgrad
Subwoofer Crossover
…(the 4 Pi speakers and modified Pi 3 flanking subs I built and documented here were the first step). To that end, I am suplementing my Onkyo TX-SR805 THX Ultra2 7.1 A/V Receiver by adding an Odyssey Audio Khartago Extreme amp (2009 TAS Amplifier of the …
6 Forum: Speaker «» Posted on: Tue, 05 April 2011 15:24 «» By: Wayne Parham
Room modes, multisubs and flanking subs
…with dual woofers, blended mid/woofer or flanking subs. In any case, the blending of the two sources should not need to be run higher than the Schroeder frequency. A pair of woofers in the same cabinet, for example, may have a lower "helper" …
7 Forum: Pi Speakers «» Posted on: Mon, 09 December 2019 10:47 «» By: Wayne Parham
Re: 4PI Plans Request
…mentioning anyway. I highly recommend flanking subs be used. They work very well with my mains or with DIYSG speakers. They are a subset of the multisub concept, which is another thing I advise. But if you want to start small, use two flanking subs …
8 Forum: Speaker «» Posted on: Wed, 26 October 2016 15:08 «» By: jonone
Small speaker flanking sub limitations.
…idea of running your mains full range with flanking subs is to have as many speakers overlapping as possible to help smooth the response. But if your speakers are relatively small is there some actual benefit in crossing them over at 80hz etc like the …
9 Forum: Pi Speakers «» Posted on: Wed, 23 December 2020 19:19 «» By: ooheadsoo
Flanking subs with multi-sub optimizer, and other questions
…f-2 (ported, tuned around 25hz). For use as flanking subs, I currently have two Dayton RSS265HF-8 woofers on each side, each pair of woofers in a Linkwitz specified W-frame cabinet, i.e., dipole. My plan A is to do the least amount of work (and …
10 Forum: Room Acoustics «» Posted on: Wed, 04 October 2017 15:59 «» By: Wayne Parham
Re: Small-room acoustics
…metrically-placed distributed multisubs 3. Flanking subs Each of these ideas have merits, and some can be used mix-and-match. The basic idea is to have multiple bass sound sources, and most experts agree that the more subs you use, the better. Also…
Pages (9): [1  2  3  4  5  6  7  8  9    »]

Current Time: Fri Apr 18 15:53:07 CDT 2025

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest