AudioRoundTable.com: Pi Speakers » 2pi studio build (some progress)

Home » Sponsored » Pi Speakers » 2pi studio build (some progress)

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: 2pi studio build (some progress) [message #67869 is a reply to message #67867]

Thu, 26 May 2011 18:17

justphil
Messages: 114
Registered: December 2010

Viscount

I didn't build a "they", I built just 1 =) It sounds awesome in my system. I wanted a 2pi studio for my center channel and now I will build my 2pi towers around the end of the year if money allows. Then I will finish it all off with a pair of 1pis and another sub. At that point I know I won't need to change anything for a looooong time =)

Report message to a moderator

Re: 2pi studio build (some progress) [message #67870 is a reply to message #67815]

Thu, 26 May 2011 19:52

Bill Epstein
Messages: 1088
Registered: May 2009
Location: Smoky Mts. USA

Illuminati (2nd Degree)

Wayne Parham wrote on Mon, 23 May 2011 18:14

Clamp pressure length all depends on the glue you use. I think Tightbond or PL adhesive is going to be fully set (or at least enough to no longer need clamping pressure) in a few hours. But some white glues need longer.

Like Wayne said, you can remove the clamps in as little as an hour with PVA glues like Titebond or Elmers but I would avoid moving them around much or especially routing the speaker holes for 24 hours.

Report message to a moderator

Pages (2): [ « ‹ 1 2]

Previous Topic:	Request 4Pi and 2Pi plans please
Next Topic:	Three Pi push-pull sub plans?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Nov 18 23:42:04 CST 2024