AudioRoundTable.com: Pi Speakers » Two PI depth adjustment

Home » Sponsored » Pi Speakers » Two PI depth adjustment

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Two PI depth adjustment [message #97813 is a reply to message #97812]

Sun, 30 June 2024 17:47

Tronographic
Messages: 9
Registered: March 2021

Esquire

Thanks Wayne...

I used this to figure out how much to increase the depth to compensate for the thicker panels, since I already had the height and width locked in.

https://www.the12volt.com/caraudio/boxcalcs.asp#rec

Increasing the depth about a 1/2" to 15-1/2" got the volume pretty close to the same as the stock dimensions

So I ended up with about 10-5/8" deep, I had to fudge the volume of the braces and cleats... And my width actually ended up at 14-15/16" after it was all glued up. So I figured better to round up than round down...

Also, if I decide to roundover the port front say with a 1/2" roundover for aesthetics, do I measure the port length from right behind the rounded portion? Basically the straight section of the port?

Thanks!

Attachment: IMG_1642 2.JPG
(Size: 3.93MB, Downloaded 44 times)

Report message to a moderator

[Message index]

		Two PI depth adjustment By: Tronographic on Sun, 30 June 2024 13:54
		Re: Two PI depth adjustment By: Wayne Parham on Sun, 30 June 2024 17:12
		Re: Two PI depth adjustment By: Tronographic on Sun, 30 June 2024 17:47
		Re: Two PI depth adjustment By: Wayne Parham on Sun, 30 June 2024 18:21

Previous Topic:	Barkyard BBQ Drive-in Theater Speakers....
Next Topic:	Pi midhorn with AE TD10m

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Oct 28 11:09:22 CDT 2024