Home » Audio » Source » Practical limit to tube based phono preamps
Re: Practical limit to tube based phono preamps [message #96277 is a reply to message #96275] Sun, 15 January 2023 22:13 Go to previous messageGo to previous message
positron is currently offline  positron
Messages: 106
Registered: May 2020
Viscount
Wayne Parham wrote on Fri, 13 January 2023 17:18

I'm with you there. The most annoying noise to me - by far - is power supply hum. If a tube amp keeps that down below audibility, it's a big deal to me. That's so rare. This is especially true when you stack all tube phono stage, preamp and power amps, and drive high-efficiency speakers. That combination is tough to get dead-black quiet, but it's so important.
So true. I personally designed at least 4 stages of filtering in my amps pre output stage, and I went from 5 to 6 stages of power supply filtering for my preamplifier. I use 2 chassis design, and 6 stages of filtering in my phono stage as well.

Cheers

pos
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: STD 305M with SME Series 3 Arm, Which Protractor
Next Topic: Saved On Vinyl
Goto Forum:
  


Current Time: Fri Jul 19 23:24:04 CDT 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest