AudioRoundTable.com: Pi Speakers » MDO

Home » Sponsored » Pi Speakers » MDO - Instead of Plywood (Materials)

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: MDO - Instead of Plywood [message #95618 is a reply to message #95617]

Fri, 13 May 2022 16:54

rvsixer
Messages: 58
Registered: February 2011

Baron

Cut your stock about 1/16" oversize on any exposed edges (be it baltic or MDF/HDF). Use a flush trim bit in a router for a perfect matching edge everytime.

Access to new Baltic birch right now is all but impossible due to a certain conflict. I am looking into Eucalyptus ply right now, its supposed to be void free etc. Otherwise I am going to use my most hated fab material MDF Evil or Very Mad

Report message to a moderator

[Message index]

		MDO - Instead of Plywood By: iplayforme on Thu, 12 May 2022 18:01
		Re: MDO - Instead of Plywood By: Rusty on Fri, 13 May 2022 06:33
		Re: MDO - Instead of Plywood By: Wayne Parham on Fri, 13 May 2022 08:43
		Re: MDO - Instead of Plywood By: iplayforme on Fri, 13 May 2022 13:24
		Re: MDO - Instead of Plywood By: rvsixer on Fri, 13 May 2022 16:54
		Re: MDO - Instead of Plywood By: iplayforme on Fri, 13 May 2022 19:22
		Re: MDO - Instead of Plywood By: rvsixer on Fri, 13 May 2022 19:26
		Re: MDO - Instead of Plywood By: iplayforme on Fri, 13 May 2022 20:26
		Re: MDO - Instead of Plywood By: Rusty on Sat, 14 May 2022 06:38
		Re: MDO - Instead of Plywood By: iplayforme on Sun, 15 May 2022 13:59

Previous Topic:	4Pi - alternate compression driver mounting?
Next Topic:	port and insulation

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Jul 15 03:05:35 CDT 2024