AudioRoundTable.com: Thermionic Emissions » is ok to put a tube PRE in front of SS amp?

Home » Audio » Thermionic Emissions » is ok to put a tube PRE in front of SS amp?

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

It may also affect power-down too [message #9477 is a reply to message #9467]

Thu, 05 January 2006 11:41

GarMan
Messages: 960
Registered: May 2009

Illuminati (2nd Degree)

For my Grounded Grid pre-amp and Gainclone combo, I get the infamous "pop" if the amp is turned on first. Pre-amp has to warm up for 15 seconds first to allow the caps to settle.

To power off, amp must be down and out first before preamp or else I get the same "pop". But this may be specific to only my system.

Report message to a moderator

[Message index]

		is ok to put a tube PRE in front of SS amp? By: paba on Tue, 27 December 2005 20:53
		Yes, No, Maybe.... By: Old Brown Eyes on Wed, 28 December 2005 05:32
		Re: Yes, No, Maybe.... By: paba on Wed, 28 December 2005 07:00
		Re: Yes, No, Maybe.... By: 2wo on Wed, 28 December 2005 16:14
		Re: Yes, No, Maybe.... By: PakProtector on Thu, 29 December 2005 20:42
		There is a simple solution to the problem By: Old Brown Eyes on Fri, 30 December 2005 06:36
		Re: There is a simple solution to the problem By: PakProtector on Fri, 30 December 2005 07:07
		It may also affect power-down too By: GarMan on Thu, 05 January 2006 11:41
		Power up, down sequence By: Shane on Sat, 07 January 2006 22:10

Previous Topic:	NOS Tubes Picture Library to ID tubes
Next Topic:	New tungsols from SRS tubes and hickock results

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Nov 27 19:54:20 CST 2024