Home » Sponsored » Pi Speakers » 3 Pi plans
Re: 3 Pi plans [message #89861 is a reply to message #86772] Thu, 28 February 2019 05:52 Go to previous messageGo to previous message
Mabob is currently offline  Mabob
Messages: 23
Registered: December 2017
Location: Finland
Chancellor
Hello

I´m back with a few pictures of the finished speakers. I've been enjoying them for a few months now and this is how the setup in my Man cave/garage look right now.

The coating is a tinted acrylic lacquer which was a pain to apply evenly. Next cabinets will definitely be veneered.

My listening impressions so far is that the high end is very good. There's no harshness whatsoever even if you really crank it up! I can also hear vocals like never before Smile Loads of stuff I didn't even know that was there!

Bass extension is not enough for my liking/room, therefore I built a BFM Table Tuba to take care of the lowest notes. I still feel that on certain music/recordings there is a bit too little attack/energy on drums or even guitar? Hard to put a finger on it... Anyone else experienced something like this? Using a Onkyo home theater amp, but haven't used Audyssey for calibration.

Overall very impressed and happy with the speakers!

Mathias

/forum/index.php?t=getfile&id=2337&private=0

/forum/index.php?t=getfile&id=2338&private=0
  • Attachment: 3pi2.jpg
    (Size: 1.97MB, Downloaded 1014 times)
  • Attachment: 3pi4.jpg
    (Size: 942.31KB, Downloaded 1147 times)
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: 2 Pi completed
Next Topic: Pi
Goto Forum:
  


Current Time: Thu Nov 21 22:59:36 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest