Home » Audio » Thermionic Emissions » Tono Preamp
Some more answers. [message #8943 is a reply to message #8938] Sun, 08 May 2005 21:44 Go to previous messageGo to previous message
Poindexter is currently offline  Poindexter
Messages: 108
Registered: May 2009
Viscount
Jarrah is dry, hard, brittle.  It glues up with PVA (I use Titebond II) very well. Walnut, Cherry, Maple are noble woods; do not say 'stuck'.  Maple is one of my all time fave woods.

The 6P1P is not a 6AQ5, any more than the 6AQ5 is a 6V6.  It'a a mystery to me why these two devices have been touted as equivalent on the auction sites; since they do not even have the same basing or envelope.  I sympathize; I have been corresponding with a gentleman in G. Britain about his Svet (real, St. Pete) 6AQ5's for a week now, and they are actually not, they're 6P1P's and will not fit my gear.  Strange.

I did not select this tube, it selected me.  I was looking for a line amp tube with lower (about ten) mu, and lower (about 2K) rp, and saw it in the tube manual.  Beam tube, but I've been using beam tubes and pentodes in triode since day one, so hey.  Looking on the vendor sites, I saw that it shifts typically for $2-5, so how could I lose?  First guess, whooda thunk it would be so fab?  I got quad of brand-matched quads from Alltronics, and they made de Poinz look so-o smart.  Don't tell, now.

Poinz

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: High Power Output SET
Next Topic: Air Dialectric caps
Goto Forum:
  


Current Time: Sun Nov 24 20:12:13 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest