Home » Sponsored » Pi Speakers » 4Pi Rough concept
Re: 4Pi Rough concept [message #88161 is a reply to message #88150] Sun, 10 June 2018 20:36 Go to previous messageGo to previous message
ggnarley is currently offline  ggnarley
Messages: 21
Registered: May 2018
Location: Ohio
Chancellor
Starting to look like a speaker now.

index.php?t=getfile&id=2137&private=0

Had to remove some of inside trim as it was interfering with the port tube.

index.php?t=getfile&id=2138&private=0

Finished inside of box

index.php?t=getfile&id=2139&private=0

Got to finally listen to just the woofer a bit. Hooked it up as right channel and kept existing small bookshelf speaker as left. Didn't have all ports on cabinet sealed and no insulation or bracing. Sounding much more like a speaker. Was amazed by how much the box was resonating at only 5 watts. The back panel was just tapped in place without any screws, and it felt like rubber. I've only had small bookshelf speakers prior to this and didn't realize how powerful this speaker will be. Definitely going to brace as recommended, and then some.

Paul
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: 7Pi Plans request
Next Topic: 3pi crossover
Goto Forum:
  


Current Time: Thu Nov 28 23:25:12 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest