Home » Sponsored » Pi Speakers » 4 Pi Build Progress
Re: 4 Pi Build Progress [message #81566 is a reply to message #81565] Fri, 04 September 2015 11:43 Go to previous messageGo to previous message
BobTahoe is currently offline  BobTahoe
Messages: 32
Registered: July 2015
Location: Lake Tahoe , NV
Baron
Got the rest of the 4pi's painted only a bit of overspray and some dust to clean up but all in all the look pretty good.

I picked up some Foam gasket tape for the speakers and waveguides. Will this also be ok for the cross over? Could I just mount the cross over on cork? or with a bead of silicon under it?

Only other thing to do is to test my 2226h's this weekend just to make sure they are original cones as was descried when I purchased them. Was going to do it outdoors but it's been so windy lately the noise from all the trees and everything has been too much. I might try and indoor test hopefully it will yield ok results.

Should have this all finished up soon just waiting on my delivery from Wayne Very Happy .
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Just Loaded in 4 Pis
Next Topic: Implementation
Goto Forum:
  


Current Time: Tue Nov 26 03:40:12 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest