Home » Sponsored » Pi Speakers » 4 Pi Build Progress
Re: 4 Pi Build Progress [message #81481 is a reply to message #81479] Thu, 23 July 2015 15:19 Go to previous messageGo to previous message
BobTahoe is currently offline  BobTahoe
Messages: 32
Registered: July 2015
Location: Lake Tahoe , NV
Baron
Thanks for the update Wayne, I understand it could take some time to get the finally parts for this build. That gives me time to get these cabs painted up nicely (I Hope).

To power the subs I ended up going the MiniDSP plus rackmount amp, When I ordered it this week I assumed the 3Pi subs were 6ohm Lab12s but latter realized they are 4ohm. The Crown XLS 2000 amp I purchased should be good for 650 watts per channel @ 4 ohm. So I imagine it's a bit more then the 3 pi's need.

Also been considering using a router to round the edges of the cabinets, is there any reason not to do this? My plan is to use a router and corner rounding bit.
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Just Loaded in 4 Pis
Next Topic: Implementation
Goto Forum:
  


Current Time: Tue Nov 26 03:44:22 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest