Home » Sponsored » Pi Speakers » 4 pi speakers + 3 pi subwoofers, pics & measurements (How to interpret the measurements?)
Re: 4 pi speakers + 3 pi subwoofers, pics & measurements [message #81366 is a reply to message #81364] Sat, 30 May 2015 11:28 Go to previous messageGo to previous message
vandevoordekoen is currently offline  vandevoordekoen
Messages: 18
Registered: January 2013
Chancellor
Hello Wayne,

Both compression drivers are B&C DE250 drivers with H290C horns bought on the 4PI-webshop. Both drivers show the same unusual roll-off.

According to your previous post, I understand that the DE250/H290C combination doesn't need extra CD compensation (with an extra C1) because the crossover-design on its own already compensates enough for this CD/horn combination?

This is a picture of the crossover:

index.php?t=getfile&id=1729&private=0


1. No C1 is installed

2. An extra resistor (over the tweeter) is installed (to reduce the possible peak at 1.6khz with the H290C horn).

3. R3 (the Zobel) isn't a large silver block (as seen often in the 4pi crossover pictures), but two 15ohm/50W resistors connected parallel.


Nothing of this should cause problems, should it? Or do I overlook something?

Maybe it is an incredible coincidence that both mics show the same roll-off?

Thanks in advance.
  • Attachment: IMG_0174.JPG
    (Size: 174.52KB, Downloaded 3823 times)
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: 4Pi Crossover Update
Next Topic: 2pi plans
Goto Forum:
  


Current Time: Wed Nov 27 02:51:21 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest