AudioRoundTable.com: Pi Speakers » 2pi, 3pi, Zaph ZA5.3 for In-Wall LCR?

Home » Sponsored » Pi Speakers » 2pi, 3pi, Zaph ZA5.3 for In-Wall LCR? (Need help deciding what to do!)

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: 2pi, 3pi, Zaph ZA5.3 for In-Wall LCR? [message #80440 is a reply to message #80437]

Tue, 09 September 2014 16:21

Wayne Parham
Messages: 18786
Registered: January 2001

Illuminati (33rd Degree)

Push that lowest mode up above 300Hz. The lower mids are where we start losing damping from the insulation, so raise that up a bit. You can also use a sheet of insualtion spanning the cross-section to increase its damping ability in the lower midrange frequencies.

Report message to a moderator

[Message index]

		2pi, 3pi, Zaph ZA5.3 for In-Wall LCR? By: corradizo on Thu, 28 August 2014 12:33
		Re: 2pi, 3pi, Zaph ZA5.3 for In-Wall LCR? By: Wayne Parham on Fri, 29 August 2014 11:41
		Re: 2pi, 3pi, Zaph ZA5.3 for In-Wall LCR? By: corradizo on Sat, 30 August 2014 07:19
		Re: 2pi, 3pi, Zaph ZA5.3 for In-Wall LCR? By: Wayne Parham on Sat, 30 August 2014 09:55
		Re: 2pi, 3pi, Zaph ZA5.3 for In-Wall LCR? By: corradizo on Sat, 30 August 2014 11:20
		Re: 2pi, 3pi, Zaph ZA5.3 for In-Wall LCR? By: Wayne Parham on Sun, 31 August 2014 07:07
		Re: 2pi, 3pi, Zaph ZA5.3 for In-Wall LCR? By: corradizo on Tue, 09 September 2014 11:00
		Re: 2pi, 3pi, Zaph ZA5.3 for In-Wall LCR? By: Wayne Parham on Tue, 09 September 2014 16:21

Previous Topic:	My new 4Pis
Next Topic:	B&C Schematics

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Nov 24 21:11:53 CST 2024