Home » Audio » Silicon Valley » ZUS and Seal Electronics DIY amplifier
Re: ZUS and Seal Electronics DIY amplifier [message #7699 is a reply to message #7689] Sat, 22 May 2004 09:22 Go to previous messageGo to previous message
Pat is currently offline  Pat
Messages: 7
Registered: May 2009
Esquire
Right now I am using Energy’s C7 front speakers and 15” Cerwin Vega D9’s in the rear for the bass all driven by that one two channel amp until I make it into a four channel. I also have a set of PSB gold series’ speakers, that have more bottom end and less top than the Energy C7’s, so there is no need for more bottom end when you have 15” speakers pumping but the top end of the Energy’s make a better match with the Vega’s, let me tell you this amp has power to drive all these speakers and then some!!!!! AS for the source I’m using a Marantz CD player and a Yamaha receiver for now. The Kenwood CD player made a nice case for this amplifier, don’t you think…..

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: NAD C350
Next Topic: Is my Pass Aleph 3 outdated?
Goto Forum:
  


Current Time: Mon Aug 12 21:23:15 CDT 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest