AudioRoundTable.com: Pi Speakers » Skywave's 3 Pi Build

Home » Sponsored » Pi Speakers » Skywave's 3 Pi Build

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Skywave's 3 Pi Build [message #75547 is a reply to message #75546]

Sat, 16 February 2013 23:07

Wayne Parham
Messages: 18786
Registered: January 2001

Illuminati (33rd Degree)

Yeah, I suppose it could be a little out of round without rubbing. The gap tolerance isn't like hydrodynamic bearing clearance, nothing even close to that. It couldn't be and still allow room for thermal shifts. But it is best that the former be round and centered in the gap.

Report message to a moderator

[Message index]

		Skywave's 3 Pi Build By: skywave-rider on Sat, 16 February 2013 17:08
		Re: Skywave's 3 Pi Build By: Wayne Parham on Sat, 16 February 2013 17:39
		Re: Skywave's 3 Pi Build By: skywave-rider on Sat, 16 February 2013 20:07
		Re: Skywave's 3 Pi Build By: Wayne Parham on Sat, 16 February 2013 23:07
		Re: Skywave's 3 Pi Build By: skywave-rider on Sun, 17 February 2013 18:25
		Re: Skywave's 3 Pi Build By: Wayne Parham on Mon, 18 February 2013 09:28
		Re: Skywave's 3 Pi Build By: rkeman on Mon, 18 February 2013 06:05
		Re: Skywave's 3 Pi Build By: skywave-rider on Mon, 18 February 2013 11:59
		Re: Skywave's 3 Pi Build By: skywave-rider on Wed, 20 February 2013 11:06
		Re: Skywave's 3 Pi Build By: Wayne Parham on Wed, 20 February 2013 11:13
		Re: Skywave's 3 Pi Build By: skywave-rider on Wed, 20 February 2013 11:58
		Re: Skywave's 3 Pi Build By: Wayne Parham on Wed, 20 February 2013 12:07

Previous Topic:	Buffer for my system?
Next Topic:	2Pi's completed - now I want a center channel

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Nov 27 05:45:35 CST 2024