AudioRoundTable.com: Pi Speakers » Why mount crossover components to separate board?

Home » Sponsored » Pi Speakers » Why mount crossover components to separate board?

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Why mount crossover components to separate board? [message #73776 is a reply to message #73775]

Tue, 11 September 2012 07:55

mantha3
Messages: 72
Registered: May 2012
Location: Lino Lakes, MN

Viscount

Ahhh, that is what I was thinking.

I did notice in the X-Over schematic by Wayne it mentions that this resistor R3 is "Mounted off board". Is this due to heat or something?

I'm going to be building soon and the X Over is something I'll do soon. Doing the 5 resistors like you will save some $$$ so I think I'll copy you on this.

Keep posting build stuff/photos. I'll do the same.

Report message to a moderator

[Message index]

		Why mount crossover components to separate board? By: Silas on Mon, 10 September 2012 12:10
		Re: Why mount crossover components to separate board? By: mantha3 on Mon, 10 September 2012 16:31
		Re: Why mount crossover components to separate board? By: mantha3 on Mon, 10 September 2012 16:33
		Re: Why mount crossover components to separate board? By: Silas on Tue, 11 September 2012 03:36
		Re: Why mount crossover components to separate board? By: mantha3 on Tue, 11 September 2012 07:55
		Re: Why mount crossover components to separate board? By: Silas on Tue, 11 September 2012 12:18
		Re: Why mount crossover components to separate board? By: Wayne Parham on Wed, 12 September 2012 23:32
		Re: Why mount crossover components to separate board? By: mantha3 on Thu, 13 September 2012 07:33
		Re: Why mount crossover components to separate board? By: Wayne Parham on Thu, 13 September 2012 08:19

Previous Topic:	4Pi stand height for home theater usage
Next Topic:	7pi plans, please

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Nov 29 12:00:25 CST 2024