Home » Sponsored » Pi Speakers » Wayne, question about Vifa DX-25
Re: Wayne, question about Vifa DX-25 [message #73135 is a reply to message #73134] Mon, 25 June 2012 21:07 Go to previous messageGo to previous message
Wayne Parham is currently offline  Wayne Parham
Messages: 18786
Registered: January 2001
Illuminati (33rd Degree)

Honestly, the new tweeter is real, real close to the old tweeter. They made a good copy. The measurements I get from both are so close you get as much difference moving the microphone around.

There are a couple peaks that might get up to 95dB, but average sensitivity is lower than that, between 93dB and 94dB. It's about a decibel higher between 1kHz and 5kHz than it is between 5kHz and 10kHz too. A gradual downward trend up into the top octave.

As for whether or not I'd put an old tweeter on one side and a new tweeter on the other, I think I probably wouldn't. I suppose that's kind of a perfectionist thing, 'cause they really are close. But still, they just don't cost much money so I'd probably swap 'em both.

 
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Pi one port
Next Topic: auralex wedges in place of R13
Goto Forum:
  


Current Time: Sun Nov 24 17:19:55 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest