Home » Audio » Group Build » IR Remote Control
Re: IR Remote Control [message #72879 is a reply to message #72841] Thu, 31 May 2012 13:52 Go to previous messageGo to previous message
skywave-rider is currently offline  skywave-rider
Messages: 104
Registered: May 2009
Viscount
Wayne,
I have not gotten the IR receiver (4838) yet, but looking at your build, it appears that an approx. 1/2" hole is sufficient. I will size it when the order arrives, but I am wondering about mounting options for that. Spec sheet assumes circuit board mounting, but I may glue it to the front panel and extend leads. Another option would be to mount it on a perfboard and line the face up with the hole in the panel. So I guess the question is, do you think it will have decent angle of acceptance butted up behind a 3/16" panel with a round hole?
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Microphone Interface
Next Topic: RIAA preamp project
Goto Forum:
  


Current Time: Sun Nov 24 04:01:22 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest