Home » Sponsored » Pi Speakers » Audition in Austin
Re: Audition in Austin [message #72640 is a reply to message #71681] Wed, 09 May 2012 11:50 Go to previous messageGo to previous message
dutchswan0311 is currently offline  dutchswan0311
Messages: 102
Registered: June 2011
Location: Iowa
Viscount
I didn't know there was an option between the three or two nuts. I used the three holes, and could not get the nut on with washers on first. I ended up just putting the nut on by itself and tightened it as hard as I could with needle nose pliers. Will my solution present issues in the future?
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: 4pi vs 3pi plans
Next Topic: 4pi Commercial Dinner Theater Build
Goto Forum:
  


Current Time: Sat Nov 23 10:01:56 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest