AudioRoundTable.com: Pi Speakers » H290 bumps / texture inside of horn

Home » Sponsored » Pi Speakers » H290 bumps / texture inside of horn - ok to sand down to smooth?

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: H290 bumps / texture inside of horn - ok to sand down to smooth? [message #71776 is a reply to message #71772]

Wed, 14 March 2012 21:23

Wayne Parham
Messages: 18738
Registered: January 2001

Illuminati (33rd Degree)

Yes, it's fine. Sand away!

The riser marks are the big bumps on the face. The little goosebumps you're talking about are just texture, a form of finish that hides surface irregularities. The riser marks are actually formed where the plastic is injected into the mold. Both can be finish-sanded smooth. Just be careful and don't go so far that the throat opens up. Only take off enough to remove the texture and make 'em smooth.

Report message to a moderator

[Message index]

		H290 bumps / texture inside of horn - ok to sand down to smooth? By: Maxjr on Wed, 14 March 2012 17:08
		Re: H290 bumps / texture inside of horn - ok to sand down to smooth? By: Wayne Parham on Wed, 14 March 2012 21:23
		Re: H290 bumps / texture inside of horn - ok to sand down to smooth? By: Maxjr on Wed, 14 March 2012 23:18
		Re: H290 bumps / texture inside of horn - ok to sand down to smooth? By: Wayne Parham on Wed, 14 March 2012 23:54
		Re: H290 bumps / texture inside of horn - ok to sand down to smooth? By: Maxjr on Thu, 15 March 2012 03:11

Previous Topic:	Center Channel with 6pi Corner Horns
Next Topic:	Let's talk about 4Pi Speaker Stands =p

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Aug 07 02:03:04 CDT 2024