Home » Sponsored » Pi Speakers » skywave's 3Pi subwoofer build (skywave's 3Pi subwoofer build)
Re: skywave's 3Pi subwoofer build [message #71632 is a reply to message #71617] Thu, 01 March 2012 22:44 Go to previous messageGo to previous message
Psychoacoustic is currently offline  Psychoacoustic
Messages: 75
Registered: May 2009
Viscount
Just one thing, mate- are you planning on leaving the thickish (10mm?) supplied gasket under the woofer frame? I queried this, Wayne said it stays. If so (I used those same mounting flanges as well), you'll need to fashion spacers for under the flanges to allow for the thickness of the gasket.
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Alternate idea for 7Pi midhorn enclosure?
Next Topic: Information about the 3 Pi Subwoofer
Goto Forum:
  


Current Time: Sat Nov 23 23:13:12 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest