AudioRoundTable.com: Pi Speakers » Since no one asked...PSA: Drill Size Chart

Home » Sponsored » Pi Speakers » Since no one asked...PSA: Drill Size Chart

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Since no one asked...PSA: Drill Size Chart [message #71011 is a reply to message #70911]

Mon, 16 January 2012 09:38

skywave-rider
Messages: 104
Registered: May 2009

Viscount

Hey Bill, stupid question: are the Countersink/Taper Point Drill Combos on the Fuller page you linked to used for drilling pilots with a built-in countersink? May seem obvious, but I don't recall using a bit like that.

Report message to a moderator

[Message index]

		Since no one asked...PSA: Drill Size Chart By: Bill Epstein on Sun, 08 January 2012 07:25
		Re: Since no one asked...PSA: Drill Size Chart By: Wayne Parham on Sun, 08 January 2012 10:17
		Re: Since no one asked...PSA: Drill Size Chart By: Bill Epstein on Sun, 08 January 2012 15:46
		Re: Since no one asked...PSA: Drill Size Chart By: Wayne Parham on Sun, 08 January 2012 15:52
		Re: Since no one asked...PSA: Drill Size Chart By: petew on Mon, 09 January 2012 08:49
		Re: Since no one asked...PSA: Drill Size Chart By: skywave-rider on Mon, 16 January 2012 09:38

Previous Topic:	Mid Horn Throat Covering?
Next Topic:	3pi subwoofer plan

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Nov 22 21:52:21 CST 2024