AudioRoundTable.com: Pi Speakers

Home » Sponsored » Pi Speakers » Alpha 10 modeling

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Alpha 10 modeling [message #70519 is a reply to message #53435]

Tue, 20 December 2011 09:48

rvsixer
Messages: 58
Registered: February 2011

Baron

Sorry for bringing back an old thread (and hope the OP does not mind). This just seemed a relevant place for my question without starting a new one.

I'm a winisd/modeling newbie, for the 2pi towers I am seeing xmax at only 2.2W input, while its posted here we can send 100W through the passband Rolling Eyes

. What am I doing wrong?

Inputs:
Alignment: tried all of them (what is the correct one, EBS?)
Volume: 129 liters
Port dia: 11.43 cm
Port length: 1.59 cm

Report message to a moderator

[Message index]

		Alpha 10 modeling By: solomty on Fri, 17 April 2009 16:09
		Re: Alpha 10 modeling By: Wayne Parham on Fri, 17 April 2009 16:37
		Re: Alpha 10 modeling By: rvsixer on Tue, 20 December 2011 09:48
		Re: Alpha 10 modeling By: Wayne Parham on Tue, 20 December 2011 13:51
		Re: Alpha 10 modeling By: rvsixer on Tue, 20 December 2011 16:17
		Re: Alpha 10 modeling By: Wayne Parham on Tue, 20 December 2011 17:00
		Re: Alpha 10 modeling By: rvsixer on Tue, 20 December 2011 18:03
		Re: Alpha 10 modeling By: Wayne Parham on Tue, 20 December 2011 18:09
		Re: Alpha 10 modeling By: rvsixer on Tue, 20 December 2011 20:14
		Re: Alpha 10 modeling By: Wayne Parham on Tue, 20 December 2011 20:28
		Re: Alpha 10 modeling By: rvsixer on Tue, 20 December 2011 20:53
		Re: Alpha 10 modeling By: Wayne Parham on Tue, 20 December 2011 21:45

Previous Topic:	1 Pi Plans
Next Topic:	1 π plans

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Nov 22 21:48:39 CST 2024