AudioRoundTable.com: Pi Speakers

Home » Sponsored » Pi Speakers » LAB12

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: LAB12 [message #69767 is a reply to message #69766]

Sun, 09 October 2011 12:14

themilford
Messages: 66
Registered: May 2009

Viscount

If it matters, the bass rolloff on the Genelecs is:

"Bass roll-off control operating in 2 dB steps from 0 to -8 dB @ 50hz"

I think the attenuation is all below 60hz maybe even lower with the "roll-off". I'll need to play around with it. there's also a "bass Tilt" control but I wouldn't be using that I don't think.

Here's the model:
http://www.genelec.com/1030a/specs/

Manual has the info on the tone switches.

Not sure we can fit two 20" cubes in the control room behind the desk... might be a tight squeeze.

Report message to a moderator

[Message index]

		LAB12 By: themilford on Sat, 08 October 2011 13:12
		Re: LAB12 By: Wayne Parham on Sat, 08 October 2011 13:23
		Re: LAB12 By: themilford on Sat, 08 October 2011 13:30
		Re: LAB12 By: skywave-rider on Sat, 08 October 2011 16:31
		Re: LAB12 By: themilford on Sat, 08 October 2011 16:55
		Re: LAB12 By: skywave-rider on Sat, 08 October 2011 17:07
		Re: LAB12 By: themilford on Sat, 08 October 2011 17:43
		Re: LAB12 By: skywave-rider on Sat, 08 October 2011 19:07
		Re: LAB12 By: Wayne Parham on Sat, 08 October 2011 23:03
		Re: LAB12 By: themilford on Sun, 09 October 2011 08:33
		Re: LAB12 By: Wayne Parham on Sun, 09 October 2011 08:55
		Re: LAB12 By: themilford on Sun, 09 October 2011 10:16
		Re: LAB12 By: Wayne Parham on Sun, 09 October 2011 11:24
		Re: LAB12 By: themilford on Sun, 09 October 2011 12:14
		Re: LAB12 By: themilford on Sun, 09 October 2011 12:22
		Re: LAB12 By: Marc321 on Mon, 10 October 2011 09:50
		Re: LAB12 By: themilford on Mon, 10 October 2011 10:34
		Re: LAB12 By: Wayne Parham on Mon, 10 October 2011 12:52
		Re: LAB12 By: themilford on Tue, 11 October 2011 11:11
		Re: LAB12 By: Wayne Parham on Tue, 11 October 2011 12:58

Previous Topic:	3 Pi Crossover/Plans Question
Next Topic:	crossovers

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Nov 23 00:57:22 CST 2024