AudioRoundTable.com: Pi Speakers » 1pi or 2pi for surrounds?

Home » Sponsored » Pi Speakers » 1pi or 2pi for surrounds?

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: 1pi or 2pi for surrounds? [message #69487 is a reply to message #68904]

Wed, 14 September 2011 21:08

smokarz
Messages: 56
Registered: June 2011
Location: CT - USA

Baron

here's the freq response as measured in REW, 3ft from speakers.

i am not quite sure what to make of it below 300hz.

wayne, any comments?

http://www.pispeakers.com/Measurements/onePi_indoor_1M_response.jpg

Report message to a moderator

[Message index]

		1pi or 2pi for surrounds? By: smokarz on Mon, 08 August 2011 08:52
		Re: 1pi or 2pi for surrounds? By: Wayne Parham on Mon, 08 August 2011 11:34
		Re: 1pi or 2pi for surrounds? By: smokarz on Mon, 08 August 2011 11:49
		Re: 1pi or 2pi for surrounds? By: Wayne Parham on Mon, 08 August 2011 14:18
		Re: 1pi or 2pi for surrounds? By: smokarz on Mon, 08 August 2011 14:46
		Re: 1pi or 2pi for surrounds? By: justphil on Tue, 09 August 2011 21:40
		Re: 1pi or 2pi for surrounds? By: smokarz on Wed, 10 August 2011 07:52
		Re: 1pi or 2pi for surrounds? By: justphil on Wed, 10 August 2011 08:12
		Re: 1pi or 2pi for surrounds? By: smokarz on Wed, 10 August 2011 09:59
		Re: 1pi or 2pi for surrounds? By: justphil on Wed, 10 August 2011 18:39
		Re: 1pi or 2pi for surrounds? By: smokarz on Tue, 16 August 2011 12:32
		Re: 1pi or 2pi for surrounds? By: Wayne Parham on Tue, 16 August 2011 14:52
		Re: 1pi or 2pi for surrounds? By: smokarz on Mon, 22 August 2011 10:02
		Re: 1pi or 2pi for surrounds? By: Wayne Parham on Mon, 22 August 2011 10:15
		Re: 1pi or 2pi for surrounds? By: smokarz on Fri, 26 August 2011 12:16
		Re: 1pi or 2pi for surrounds? By: Wayne Parham on Fri, 26 August 2011 12:40
		Re: 1pi or 2pi for surrounds? By: smokarz on Fri, 26 August 2011 12:46
		Re: 1pi or 2pi for surrounds? By: Wayne Parham on Fri, 26 August 2011 13:29
		Re: 1pi or 2pi for surrounds? By: smokarz on Sat, 27 August 2011 08:26
		Re: 1pi or 2pi for surrounds? By: justphil on Sat, 27 August 2011 08:48
		Re: 1pi or 2pi for surrounds? By: Wayne Parham on Sat, 27 August 2011 09:32
		Re: 1pi or 2pi for surrounds? By: smokarz on Sat, 27 August 2011 09:28
		Re: 1pi or 2pi for surrounds? By: smokarz on Sat, 27 August 2011 09:36
		Re: 1pi or 2pi for surrounds? By: justphil on Sat, 27 August 2011 09:53
		Re: 1pi or 2pi for surrounds? By: smokarz on Sat, 27 August 2011 10:27
		Re: 1pi or 2pi for surrounds? By: justphil on Sat, 27 August 2011 10:55
		Re: 1pi or 2pi for surrounds? By: smokarz on Tue, 30 August 2011 21:55
		Re: 1pi or 2pi for surrounds? By: Wayne Parham on Tue, 30 August 2011 22:40
		Re: 1pi or 2pi for surrounds? By: smokarz on Wed, 31 August 2011 08:54
		Re: 1pi or 2pi for surrounds? By: Wayne Parham on Wed, 31 August 2011 10:52
		Re: 1pi or 2pi for surrounds? By: smokarz on Wed, 31 August 2011 12:20
		Re: 1pi or 2pi for surrounds? By: smokarz on Tue, 06 September 2011 09:05
		Re: 1pi or 2pi for surrounds? By: justphil on Tue, 06 September 2011 09:24
		Re: 1pi or 2pi for surrounds? By: smokarz on Tue, 06 September 2011 10:20
		Re: 1pi or 2pi for surrounds? By: smokarz on Tue, 06 September 2011 12:50
		Re: 1pi or 2pi for surrounds? By: Wayne Parham on Tue, 06 September 2011 15:46
		Re: 1pi or 2pi for surrounds? By: smokarz on Tue, 06 September 2011 20:24
		Re: 1pi or 2pi for surrounds? By: Wayne Parham on Tue, 06 September 2011 21:42
		Re: 1pi or 2pi for surrounds? By: smokarz on Thu, 08 September 2011 10:10
		Re: 1pi or 2pi for surrounds? By: Wayne Parham on Thu, 08 September 2011 11:37
		Re: 1pi or 2pi for surrounds? By: smokarz on Thu, 08 September 2011 15:06
		Re: 1pi or 2pi for surrounds? By: smokarz on Sat, 10 September 2011 11:39
		Re: 1pi or 2pi for surrounds? By: Wayne Parham on Sat, 10 September 2011 16:32
		Re: 1pi or 2pi for surrounds? By: smokarz on Mon, 12 September 2011 21:57
		Re: 1pi or 2pi for surrounds? By: jshupe on Wed, 08 January 2014 21:21
		Re: 1pi or 2pi for surrounds? By: smokarz on Mon, 12 September 2011 21:58
		Re: 1pi or 2pi for surrounds? By: smokarz on Mon, 12 September 2011 22:01
		Re: 1pi or 2pi for surrounds? By: justphil on Tue, 13 September 2011 09:36
		Re: 1pi or 2pi for surrounds? By: smokarz on Tue, 13 September 2011 09:57
		Re: 1pi or 2pi for surrounds? By: Wayne Parham on Tue, 13 September 2011 10:29
		Re: 1pi or 2pi for surrounds? By: smokarz on Tue, 13 September 2011 10:59
		Re: 1pi or 2pi for surrounds? By: Wayne Parham on Tue, 13 September 2011 14:15
		Re: 1pi or 2pi for surrounds? By: smokarz on Tue, 13 September 2011 21:10
		Re: 1pi or 2pi for surrounds? By: smokarz on Wed, 14 September 2011 21:08
		Re: 1pi or 2pi for surrounds? By: smokarz on Wed, 14 September 2011 21:17
		Re: 1pi or 2pi for surrounds? By: Wayne Parham on Wed, 14 September 2011 22:10
		Re: 1pi or 2pi for surrounds? By: smokarz on Thu, 15 September 2011 07:39
		Re: 1pi or 2pi for surrounds? By: Wayne Parham on Thu, 15 September 2011 07:49
		Re: 1pi or 2pi for surrounds? By: smokarz on Thu, 15 September 2011 08:14
		Re: 1pi or 2pi for surrounds? By: Wayne Parham on Thu, 15 September 2011 10:25
		Re: 1pi or 2pi for surrounds? By: smokarz on Thu, 15 September 2011 11:32
		Re: 1pi or 2pi for surrounds? By: Wayne Parham on Thu, 15 September 2011 12:35
		Helmholtz frequency of each model By: Wayne Parham on Fri, 16 September 2011 09:41
		Re: 1pi or 2pi for surrounds? By: smokarz on Fri, 16 September 2011 18:16
		Re: 1pi or 2pi for surrounds? By: Wayne Parham on Fri, 16 September 2011 19:30
		Re: 1pi or 2pi for surrounds? By: smokarz on Sat, 17 September 2011 08:45
		Re: 1pi or 2pi for surrounds? By: Wayne Parham on Sat, 17 September 2011 09:00
		Re: 1pi or 2pi for surrounds? By: smokarz on Sat, 17 September 2011 09:16
		Re: 1pi or 2pi for surrounds? By: Wayne Parham on Sat, 17 September 2011 10:45

Previous Topic:	Flanking subs and phase
Next Topic:	Pi 3 or 4?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Nov 21 12:41:18 CST 2024