Damping resistor across the tweeter! [message #69350 is a reply to message #69316] |
Tue, 06 September 2011 08:48 |
spkrman57
Messages: 522 Registered: May 2009
|
Illuminati (1st Degree) |
|
|
JBL did that with a lot of their MF/HF drivers in their crossovers to smooth out the impedance variations reflected back to the crossover.
Try a value that is 2 X the Dcr of the driver. The lower impedance of that scenario is not as much as you think it would be affected.
It might raise the crossover frequency to the HF just a bit, but not so much that you might notice.
Ron sends...
|
|
|