AudioRoundTable.com: Pi Speakers » Damping material placement

Home » Sponsored » Pi Speakers » Damping material placement

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Damping material placement [message #69278 is a reply to message #69273]

Thu, 01 September 2011 14:50

doucanoe
Messages: 34
Registered: May 2009

Baron

I'm going to have to dig up my old 4pi plans and see where you located the cross section piece. If anything else, it will provide a point of reference.

RC

Report message to a moderator

[Message index]

		Damping material placement By: doucanoe on Thu, 01 September 2011 09:25
		Re: Damping material placement By: Wayne Parham on Thu, 01 September 2011 10:32
		Re: Damping material placement By: doucanoe on Thu, 01 September 2011 11:33
		Re: Damping material placement By: Wayne Parham on Thu, 01 September 2011 13:19
		Re: Damping material placement By: doucanoe on Thu, 01 September 2011 14:50
		Re: Damping material placement By: Wayne Parham on Thu, 01 September 2011 14:55

Previous Topic:	crossover board assembly
Next Topic:	1/2 PI Crossover

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Dec 04 02:59:49 CST 2024